T-1000S SD Card Controller For Pixel LED Light
Share This Post, Help Others

The T1000s LED Controller supports off-line control and is compatible with single-line or double-line chips. The single-port output can support 2048 pixels.

T1000s LED Controller System Features

  1. 32—256 Gray level, support software Gamma correction.
  2. Support the rules and special-shaped handle.
  3. Single-port output can support 2048 pixels.
  4. Off-line (SD Card) control, playback content stored in the SD card.
  5. T-1000s store a maximum of 16 programs, and copy multiple files to the SD card in order, after formatting the SD card as “FAT” format.
  6. The program must be named in orders just as: 00_1.led, 01_1.led, 02_1.led.
  7. Compatible with single-line or double-line chips.

T1000s LED Controller Note

  • When the T1000s LED Controller control less than 512 lamps, the frame rate can reach 30fps. When T1000s LED Controller has more than 512 lights and less than 2048 lights, the frame rate will slow down automatically.
  • T-1000s must use the new LED Edit 2014 software.

T1000s LED Controller Special Parameters

Memory Card :

  1. type: SD card(suggest using a high-speed SD card)
  2. Capacity: 128MB — 2GB
  3. Format: FAT
  4. Store file: *. Led

Physical Parameters :

  1. Temperature: -30 ℃ —85 ℃
  2. Voltage: DC5V / DC7.5-24V
  3. Power: 1W
  4. Size: L165mm × W80mm × H30mm
  5. Weight: 0.35KG
  6. Signal port: 3pin connect port

Note :

  1. Before copy files to the SD card, the SD card must be formatted in “FAT” format.
  2. The SD card in the controller can not be hot-swappable, plug the SD card every time, you must first disconnect the power supply.

T1000s LED Controller Mode of Connection:

t1000s led controller software
  1. Multiple T1000s LED Controller can be cascaded together and work synchronously.
  2. T-1000s one TTL(SPI) signal and one RS485 signal port output, can control 2048 pixels/lamps.
  3. When the chip for LED is a single line chip just with data, then just needs to be connected with DAT and GND of the controller. the chip for LED is a double line chip with DAT and CLK, then need to be connected with DAT, CLK, and GND of the controller.
  4. you need to use RS485 signal you need to connect controller A interface with LED lamps A (DMX+), controller B interface with LED lamps B (DMX-).
  5. If you need to control a new IC type by the controller, the software code mode is T-1000-IC model.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *